Fault phenomenon:
Factory output of less than standard.
Reasons:
1) was broken material hardness or toughness than the provisions of the instruction manual;
2) Anti-access electrical wiring location, a mainframe-car (a jaw clockwise rotation), or by access to motor triangle into astrocytes access method;
3) provides nesting population is less than the limit;
4) jaw plate shift , the top teeth and tooth roof relative;
5) low voltage work at the scene;
6) Fixed
jaw and bearing wear space too large, so that a relative bearing outer ring rotation.
Excluded:
1) to replace or increase crusher; 2) swapped electrical wiring;
3) nesting I adjusted to the provisions of the said statement nesting population and increased for minor crusher; 4) check from the tooth plate tooth size, such as sub-standard required replacement jaw plates, align the activities of the fixed jaw plate and the relative position of the jaw plates, addendum to ensure that the tooth root, fixed clamping to prevent displacement; 5) increase the voltage workplaces, in order to meet heavy demand mainframe; 6) the replacement of bearings or moving the jaw.
jaw crusher Fault phenomenon:
Activities work with the fixed jaw plate when beating or hit.
Reasons:
1)
jaw plates fastening bolts loose or falling; 2) nesting population is too small, the two each other at the bottom jaw plate collision.
Excluded:
1) bear fixed or external bolt; 2) align the nesting population to ensure that the correct two jaw plate gap.